Aastra Ascotel IntelliGate 2025 - Page 927

Ascotel IntelliGate 2025/2045/2065
Part 7 Operations supervision 927
• IP address of the PC if the PBX is to connect with the PC via an ISDN gateway.
If the PBX is to connect with the PC without an ISDN gateway, the IP address
entry should remain empty.
• TCP port number (the initialization value is 1062; if the value is changed in the
SEM, it will have to be altered accordingly on the PBX side.)
• User name and password of the dial-up networking of the PC or ISDN gateway,
to gain access via the TA or the ISDN gateway to the PC with the SEM.
See also:
Information on dial-up networking configuration on the PC see "Set-
tings", page 840.
Configuring a local signal destination on an Ethernet inter-
face
A PC (with the System Event Manager) connected either directly to the Ethernet
interface or to the basic system via a LAN (LAN connection) can be configured as
the local signal destination.
The event messages are displayed in PC format.
The "Local Output Interface" must be set on "IP Destination" in the Fault & Main-
tenance Manager.
The following parameters need to be selected or entered in the Fault & Mainte-
nance Manager:
• Destination: Ethernet
• IP address of the PC
• TCP port number (the initialization value is 1062; if the value is changed in the
SEM, it will have to be altered accordingly on the PBX side.)
See also:
Information on the connecting cables see "Ethernet Interface", page
799.