Aastra Ascotel IntelliGate 2025 - Page 945

Ascotel IntelliGate 2025/2045/2065
Part 7 Operations supervision 945
Tab. 7.24: Error message during software version transfer (version transfer configuration data
organization OIM)
Note:
If error codes 402 to 405 occur, the system will halt the startup. Proceed-
ing with the startup results in a system initialization.
Tab. 7.25: Self-test error messages (system unable to run)
Tab. 7.26: Self-test error messages in Xmodem mode (system unable to run)
Identification Error description Error handling
402 Version transfer not possible due to incorrect
mainboard
• Replace mainboard
403 Version transfer not possible: Version of the
PBX software used to create the configuration
data is more recent than the software currently
on the PBX
• Load new software onto mainboard
404 Version transfer not possible: Country and / or
sales channel on the PBX (EIM card) does not
match information in the configuration data
on the Flash (e.g. country code in Flash mem-
ory is CH and in the software it is D)
• Fit a different mainboard with cor-
rect country and / or distribution
channel
405 Version transfer not possible:
Software release unknown.
• Load new software onto mainboard
Identification Error description Error handling
500 Program checksum incorrect • Load correct software onto the PBX
503 Too many system restarts • Replace mainboard
504 Program error after startup • Replace mainboard or RAM card
505 DRAM SIMM defective • Replace mainboard
520 Incompatible boot software (e.g. the 2065
system cannot load I6 system software using
I5 boot software)
• New Flash card with appropriate
boot software required (e.g. from the
I6 "Update-Set")
521 Incompatible RAM size (e.g. the I6 system
2065 requires a 64MB RAM)
• New RAM card with appropriate
RAM component required (e.g. from
the I6 "Update-Set")
522 Incompatible Flash size (e.g. the I6 system
2065 requires a 8MB Flash memory)
• New Flash card with appropriate
Flash component required (e.g. from
the I6 "Update-Set")
Identification Error description Error handling
601 XMODEM transfer aborted • Retry transfer
602 XMODEM transfer rejected • Ensure that correct file is being trans-
mitted