EasyManuals Logo

ACES SYSTEMS Cobra II User Manual

Default Icon
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #189 background imageLoading...
Page #189 background image
Gen II User Manual
9-26 – Transient Balance Chapter 9 Revision 2.10, Apr 2020
9.2.5.7. After displaying a brief “Optimizing Solution” status indicator, the “Run 1 Existing
Weights?” screen will be displayed. This screen will only appear after Run #1. Select
“F1 Yes” if the first run was conducted with the previous trim balance weight
installed. Please note that existing weights and their location will need to be annotated
on the next screen. This may require the removal of that weight for verification.
Select “F5 No” if the weights were already removed or there were no existing weights
installed.
9.2.5.8. “List Run 1 Existing Weights”. From this screen, use the [] [] keys to move from
field to field. When the correct field is highlighted, use the [] [] keys to change
the value in that field. Entries in this field will either be the Hole/Position/ Blade
number or a <?> symbol. The question mark indicates an undefined location. They
are placeholders for locations which can accept weight, but haven’t been used yet.
Enter the Hole/Position/Blade number where existing weight is located. Then select

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ACES SYSTEMS Cobra II and is the answer not in the manual?

ACES SYSTEMS Cobra II Specifications

General IconGeneral
BrandACES SYSTEMS
ModelCobra II
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals