Gen II User Manual
9-31 – Transient Balance Chapter 9 Revision 2.10, Apr 2020
9.2.6. – Start Aircraft for Acceleration (Run 2)
9.2.6.1. The screen will again display the Start Aircraft banner screen and indicate a new Run
number. From this point, repeat paragraphs 9.2.5 to 9.2.5.1111 until the vibration
amplitude is reduced to an acceptable level or below the target amplitude entered in
the setup.
9.2.6.2. When the vibration levels have been reduced to a level equal to or lower than the
target value set in paragraph 9.1.3.9 above, the “Balance Status” screen will be
displayed. It informs you that the target value has been met and gives you the option
to press [F1] “Quit Job” or [F5] “Continue” to continue the balance process. Pressing
[F1] will complete the job and store any pertinent information back into the setup. If
the job went well, the Influence Coefficient (ICF) stored in the setup will be updated.
Pressing [F5] “Continue” will continue the balance job as described in step 9.2.5.
To Next Page
Loading...
Need help?
General
