Gen II User Manual
20-5 – Check Track Chapter 20 Revision 3.00, April 2020
If using a strobe - When the screen shown above appears, aim the strobe and press the trigger to
fire. The targets will appear as a stacked image.
- Use the [F3] key to spread the targets apart from each other. Each time you press the [F3] key
the targets separate further. To return the targets to the stacked position, press the [F1] “Reset”
key. To rotate the group of targets to another position for ease of viewing, press the [F2]
“Rotate” key.
After you have observed the track split, use the navigation arrows to enter each blade’s elevation.
The [] and [] arrows will move you from blade to blade, with the active blade presented in
color with a broken border (see blade B1 above). Inactive blades will be grey and have a solid
border. The [] and [] keys will change the elevation of the active blade icon. Each press will
move the blade icon 0.1 inches or 2 mm depending on the “Track Units” selected above. It is not
possible to enter Lead/Lag values through this interface. When finished, press the [F0] “Back
Up” key to exit back to the Main Menu banner screen.
Revision History:
3/10/2015 1.01: Updated broken chapter reference links in the footer and added revision history table. Berlin
1/22/2016
2.00: Major rewrite generalizing the manual to cover both the Viper II and Cobra II. This chapter was
updated with screenshots and corrections to minor typographical errors.
East
4/30/2020 3.00 Updated screens shots and minor verbiage changes Underwood
To Next Page
Loading...
