Agilent Technologies E6198B

Using Load Cards and Loads 5
E6198B Switch/Load Unit User Manual 5-75
UUT Connections
When configured as part of a standard Agilent system, P2 of the
load card is typically connected via cables to a mass
interconnect panel. User connections to the UUT are then made
from the mass interconnect panel. Refer to the appropriate
mass interconnect wiring guide for connection details. You can
also make connections directly to P2. The pinouts are the same
as for the E6176A 16-channel load card. See “UUT Connections"
for details.