Register Definitions B
E6198B Switch/Load Unit User Manual B-35
• Write Only
• State: 1 = Loadx.2 connected to Loadx
• State: 0 = Loadx.1 connected to Loadx
• Power On/Reset State = 0 (all Loadx.1 connected to Loadx)
Load Select 9-16 (W) Base + 9
h
This register controls the load selection relays for channels 9-16.
(See Figure B-10.) For x=9-16:.
• Write Only
• State: 1 = Loadx.2 connected to Loadx
• State: 0 = Loadx.1 connected to Loadx
• Power On/Reset State = 0 (all Loadx.1 connected to Loadx)
Agilent N9378A 24-Channel Low-Resistance Load Card
The Agilent N9378A low-resistance load card lets you attach as
many as four loads per channel. Loads are mounted onboard on
a series of mezzanine cards that plug into the load card. The
N9378A card also provides an output relay in a general-purpose
configuration. See “Using the Agilent E6178B 8-Channel Load
Card" for a block diagram and more information.
Unless otherwise noted, writing a 1 closes (energizes) a relay,
and writing a 0 opens (de-energizes) the relay. The reset and
power-on state for all relays is open.
Setting state state state state state state state state
Bit 76543210
Bit 76543210
Purpose
Chan16 Chan15 Chan14 Chan13 Chan12 Chan11 Chan10 Chan9
Setting state state state state state state state state
To Next Page
Loading...
Need help?
General
