Using the Pin Matrix Cards 6
E6198B Switch/Load Unit User Manual 6-9
J1 Connector Pinouts
Figure 6-5 shows the pinouts for connector J1 which provides
instrument and Abus access. J1 is available only on the Agilent
E8792A 32-Pin Matrix Card.
SHOCK HAZARD. Only service-trained personnel who are
aware of the hazards involved should install, remove, or
configure the Switch/Load Unit or plug-in cards. Before you
remove any installed card, disconnect AC power from the
mainframe and from other cards that may be connected to
the cards.
STATIC ELECTRICITY. Static electricity is a major cause of
component failure. To prevent damage to electrical
components, observe anti-static techniques whenever
removing a card from the Switch/Load Unit or whenever
working on a card.
To Next Page
Loading...
Need help?
General
