Alcatel-Lucent 9500 MXC - Page 372

Chapter 3. Installation and Configuration Process
Vol. IV-3-10 Alcatel-Lucent
11. Configuration: Alarm Actions
12. Configuration: Date/Time
13. Configuration: Software Management
14. Configuration: Security
15. Align the antenna using either the RSSI voltage at the BNC connector on the
ODU or the RSL value on 9500 MXC CT.
To view the RSL value select
Diagnostics > Performance. For details refer to
Performance, Volume IV, Chapter 15.
9500 MXC Node 9500 MXC Terminal
Select Configuration > Alarm Actions to configure
Alarm I/O mapping (if required).
Refer to 9500 MXC Node and Terminal Alarm
Actions on page 11-1 details.
Select
Configuration > Alarm Actions to configure Alarm
I/O mapping (if required).
Refer to 9500 MXC Node and Terminal Alarm Actions on
page 11-1 details.
9500 MXC Node 9500 MXC Terminal
Select Configuration > Date/Time to set the Node
date and time.
For details refer to Date and Time Configuration on
page 12-1
Select Configuration > Date/Time to set the Terminal
date and time.
For details refer to Date and Time Configuration on
page 12-1
9500 MXC Node 9500 MXC Terminal
Select Configuration > Software Management to
check and compare the loaded software against the
version supplied on the Installation CD. Where
different, load the version from the CD, which is the
latest version at the time of shipping from
Alcatel-Lucent.
Refer to Software Management on page 13-1 for
details.
Select
Configuration > Software Management to check
and compare the loaded software against the version
supplied on the Installation CD. Where different, load the
version from the CD, which is the latest version at the time
of shipping from Alcatel-Lucent.
Refer to Software Management on page 13-1 for details.
9500 MXC Node 9500 MXC Terminal
Select Configuration > Security to enable login
security for 9500 MXC CT, and to set new passwords.
Refer to Security Configuration on page 14-1 for
details.
Select Configuration > Security to enable login security
for 9500 MXC CT, and to set new passwords.
Refer to Security Configuration on page 14-1 for details.