9500 MXC User Manual
3DB 23063 ADAA - Rev 004 July 2007 Vol. IV-15-11
• If the Helpset is not available (has not been loaded on your PC), the Help for
Event tab will remain greyed-out and a Help Not Installed message will appear
below the Help for Event tab.
• The Helpset is automatically opened to the relevant alarm page when the Help
for Event tab is clicked on a valid (un-greyed) alarm selection.
• It is not necessary to have the Helpset open when the Help for Event tab is
clicked. CT automatically opens the Helpset when the tab is first clicked,
and it will remain open until closed from within the Helpset.
• The Helpset can also be directly opened to its CT pages or to the full 9500
MXC User Manual from Help in the Menu bar.
• If alarm information for a selected event is not available, the Help for Event tab
is greyed-out.
• Help is not supported for informational events (non-alarm events) or for
DAC GE and DAC 155oM alarms; full support will be provided in a later
release.
• The Help for Event tab must be clicked for each new event help selection.
• Figure 15-3 shows the event help for ESR Threshold Exceeded.
To Next Page
Loading...
