Amazone AMAPAD - Setting Flag Points for GPS Drift Correction

The flag point has been set.
6.2 Setting flag points for GPS drift correction
With the GPS drift correction, deviations in the GPS
signal can
be corrected. A flag point can be used as a
reference point in this case.
REQUIREMENTS
GPS signal with the highest possible precision is
available
Vehicle geometry is defined; see page 73
1. Drive to a distinctive position on the field that can
serve as a reference point.
NOTE
Flag points are always set at the position of the
vehicle
rear axle.
2. In the job menu, tap on
.
3. Call up the " Add marker " menu with .
4. Tap on "Custom".
001788
J | Managing fields | Setting flag point
MG5574-EN-II | B.1 | 25.10.2016
143