2.2 Interrupting the boundary line recording
Interruption with the Pause button
1. In the field menu, interrupt the boundary line
recording with
.
2. Resume the boundary line recording with .
Interruption with part-width section control
REQUIREMENTS
Function is enabled in the setup menu; see
page
40
Job is started; see page 115
1. Switch off all of the part-width sections.
The boundary line recording is interrupted.
2. T
o resume the boundary line recording:
Switch on the part-width sections.
2.3 Creating boundary lines with a shape file
Boundary lines that were previously created in a Farm
Management
Information System can be loaded as a
shape file. The shape files can be imported to the
AMAPAD using a USB stick.
REQUIREMENTS
Field is created; see page 127
Job is created and the field is added to the job;
see page
116
NOTE
If a shape file contains several boundary lines, all of
the
existing boundary lines are saved with this field.
1. Insert the USB stick with the shape file into the
AMAP
AD.
2. In the job menu, tap on
.
001835
001836
001834
001780
J | Managing fields | Creating a boundary line
MG5574-EN-II | B.1 | 25.10.2016
132
To Next Page
