Amazone AMAPAD - Correcting the GPS Drift with a Flag Point

3. Make corrections until the position of the vehicle
symbol corresponds to the real position of the
vehicle.
4. Confirm with .
1.2 Correcting the GPS drift with a flag point
REQUIREMENTS
Flag point is set as a reference; see page 143
1. Place your finger on any point on the map.
2
1
The selection confirmation
1
will be coloured after
half a second.
2. Move your finger on a flag point until the flag point
name
2
is shown.
3. Take your finger off the map.
The flag point options will be opened.
002175
L | Correcting the GPS reception| Performing the GPS drift correction
MG5574-EN-II | B.1 | 25.10.2016
160