4
Switching on the automatic steering
REQUIREMENTS
Vehicle with automatic steering is configured, see
page
71.
Suitable GPS receiver is configured (AGI-3 or
AGI-4),
see page 51.
Automatic steering is enabled, see page 79.
Steering is calibrated, see page 166.
All of the conditions for the steering status are
fulfilled, see page
168.
Automatic steering coordinated, see page 170.
The vehicle is positioned on a track line.
In the operating menu, tap on .
An alarm is issued.
The automatic steering has been started.
Button for starting the automatic steering turns
green:
NOTE
If the vehicle does not exhibit the desired driving
reaction,
the automatic steering can be coordinated
again, see page 170.
4.1 Delayed automatic steering switch-on
The automatic steering can be switched on with a delay
to be able
to accelerate the vehicle. When the required
speed has been reached, the automatic steering is
automatically switched on.
REQUIREMENTS
Vehicle speed below 2 km/h
1. Tap on
twice quickly.
flashes yellow-white.
2. Accelerate the vehicle.
005561
002540
M | Using automatic steering| Switching on the automatic steering
MG5574-EN-II | B.1 | 25.10.2016
172
To Next Page
Loading...
