Amazone AMAPAD - Adding an Application Map to a Job

The application map will be loaded.
NOTE
For the application map to be properly displayed,
the following
conditions must be fulfilled:
The "Application map" must be selected as the
"Coverage map"; see page
209.
The controllable implement element must be
selected as the VRC map; see page
211
The coverage scale must be configured; see
page
212
2
Adding an application map to a job
REQUIREMENTS
The USB stick with the application maps in shape
format is inserted into the AMAP
AD.
NOTE
Application maps must be created with the
WGS-84 coordinate system.
Application maps consist of 3 files. All 3 files
must be saved in the same folder on the USB
flash drive:
Geometry data file, file format: .shp
Factual data file, file format: .dbf
Attribute data file, file format: .shx
Job is selected; see page 121
NOTE
If an application map has already be loaded for the
job,
a different job must be selected or created.
1. In the job menu, tap on
.
2. Call up the "Rate control assignment" menu with
.
002731
Q | Using rate control| Adding an application map to a job
MG5574-EN-II | B.1 | 25.10.2016
196