AudioCodes Mediant 600 - Page 402

SIP User's Manual 402 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
Manipulation'' on page 787.
Destination Host
[IP2IPRouting_DestHost]
Defines the host part of the incoming SIP dialog’s destination URI
(usually the Request-URI). If this rule is not required, leave the field
empty. The asterisk (*) symbol can be used to denote any
destination host.
The default is "*".
Request Type
[IP2IPRouting_RequestType]
Defines the SIP dialog request type of the incoming SIP dialog.
 [0] All (default)
 [1] INVITE
 [2] REGISTER
 [3] SUBSCRIBE
 [4] INVITE and REGISTER
 [5] INVITE and SUBSCRIBE
 [6] OPTIONS
Message Condition
[IP2IPRouting_MessageCondi
tion]
Selects a Message Condition rule.
Operation Routing Rule (when match occurs in characteristics)
Destination Type
[IP2IPRouting_DestType]
Determines the destination type to which the outgoing SIP dialog is
sent.
 [0] IP Group (default) = The SIP dialog is sent to the IP Group’s
Proxy Set (SERVER-type IP Group) or registered contact from
the database (if USER-type IP Group).
 [1] Dest Address = The SIP dialog is sent to the address
configured in the following fields: 'Destination SRD ID',
'Destination Address', 'Destination Port', and 'Destination
Transport Type'.
 [2] Request URI = The SIP dialog is sent to the address
indicated in the incoming Request-URI. If the fields 'Destination
Port' and 'Destination Transport Type' are configured, the
incoming Request-URI parameters are overridden and these
fields take precedence.
 [3] ENUM = An ENUM query is sent to include the destination
address. If the fields 'Destination Port' and 'Destination
Transport Type' are configured, the incoming Request-URI
parameters are overridden and these fields take precedence.
 [4] Hunt Group = Used for call center survivability.
Destination IP Group ID
[IP2IPRouting_DestIPGroupID
]
Defines the IP Group ID to where you want to route the call. The
SIP dialog messages are sent to the IP address defined for the
Proxy Set associated with this IP Group. If you select an IP Group,
it is unnecessary to configure a destination IP address (in the
'Destination Address' field). However, if both parameters are
configured, then the IP Group takes precedence.
If the destination IP Group is of USER type, the device searches for
a match between the Request-URI (of the received SIP dialog) to
an AOR registration record in the device's database. The SIP
dialog is then sent to the IP address of the registered contact.
The default is -1.
Notes:

This parameter is only relevant if the parameter 'Destination