Version 6.4 403 March 2012
SIP User's Manual 19. Stand-Alone Survivability (SAS) Application
Parameter Description
Type' is set to 'IP Group'. However, regardless of the settings of
the parameter 'Destination Type', the IP Group is still used -
only for determining the IP Profile or outgoing SRD. If neither IP
Group nor SRD are defined in this table, the destination SRD is
determined according to the source SRD associated with the
Source IP Group (configured in the IP Group table, see
''Configuring IP Groups'' on page 195). If this table does not
define an IP Group but only an SRD, then the first IP Group
associated with this SRD (in the IP Group table) is used.
If the selected destination IP Group ID is type SERVER, the
request is routed according to the IP Group addresses.
If the selected destination IP Group ID is type USER, the
request is routed according to the IP Group specific database
(i.e., only to registered users of the selected database).
If the selected destination IP Group ID is ANY USER ([-2]), the
request is routed according to the general database (i.e., any
matching registered user).
Destination SRD ID
[IP2IPRouting_DestSRDID]
Defines the SRD ID. The default is None.
Note: The destination IP Group must belong to the destination
SRD, if both are configured in this table.
Destination Address
[IP2IPRouting_DestAddress]
Defines the destination IP address (or domain name, e.g.,
domain.com) to where the call is sent.
Notes:
This parameter is applicable only if the parameter 'Destination
Type' is set to 'Dest Address' [1].
When using domain names, enter a DNS server IP address or
alternatively, define these names in the 'Internal DNS Table'
(see ''Configuring the Internal SRV Table'' on page 124).
Destination Port
[IP2IPRouting_DestPort]
Defines the destination port to where the call is sent.
Destination Transport Type
[IP2IPRouting_DestTransport
Type]
Defines the transport layer type for sending the call:
[-1] Not Configured (default)
[0] UDP
[1] TCP
[2] TLS
Note: When this parameter is set to -1, the transport type is
determined by the parameter SIPTransportType.
Alternative Route Options
[IP2IPRouting_AltRouteOptio
ns]
Determines whether this routing rule is the main routing rule or an
alternative routing rule (to the rule defined directly above it in the
table).
[0] Route Row (default) = Main routing rule - the device first
attempts to route the call to this route if the incoming SIP
dialog's input characteristics matches this rule.
[1] Alt Route Ignore Inputs = If the call cannot be routed to the
main route (Route Row), the call is routed to this alternative
route regardless of the incoming SIP dialog's input
characteristics.
[2] Alt Route Consider Inputs = If the call cannot be routed to
the main route (Route Row), the call is routed to this alternative
route only if the incoming SIP dialog matches this routing rule's
To Next Page
Loading...
