AudioCodes Mediant 600 - Page 582

SIP User's Manual 582 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
Mediant 600.
 For a detailed description of the ini file table's parameters and for
configuring this table using the Web interface, see 'Configuring IP
Groups' on page 195.
 For configuring ini file table parameters, see 'Configuring ini File
Table Parameters' on page 84.
Web: Authentication Table
EMS: SIP Endpoints > Authentication
[Authentication]
This parameter table defines a user name and password for
authenticating each device port. The format of this parameter is as
follows:
[Authentication]
FORMAT Authentication_Index = Authentication_UserId,
Authentication_UserPassword, Authentication_Module,
Authentication_Port;
[\Authentication]
Where,
 UserId = User name
 UserPassword = Password
 Module = Module number (where 1 denotes the module in Slot 1)
 Port = Port number (where 1 denotes the Port 1 of the module)
For example:
Authentication 0 = john,1325,1,1; (user name "john" with password 1325
for authenticating Port 1 of Module 1)
Authentication 1 = lee,1552,1,2; (user name "lee" with password 1552
for authenticating Port 2 of Module 1)
Notes:
 The indexing of this parameter starts at 0.
 The parameter AuthenticationMode determines whether
authentication is performed per port or for the entire device. If
authentication is performed for the entire device, the configuration in
this table parameter is ignored.
 If the user name or password are not configured, the port's phone
number (configured using the parameter TrunkGroup - Trunk Group
Table) and global password (using the individual parameter
Password) are used for authentication.
 Authentication is typically used for FXS interfaces, but can also be
used for FXO interfaces.
 For configuring the Authentication table using the Web interface, see
Configuring Authentication on page 325.
 For configuring ini file table parameters, see 'Configuring ini File
Table Parameters' on page 84.
Account Table
Web: Account Table
EMS: SIP Endpoints >
Account
[Account]
This parameter table configures the Account table for registering and/or
authenticating (digest) Trunk Groups or IP Groups (e.g., an IP-PBX) to a
Serving IP Group (e.g., an Internet Telephony Service Provider - ITSP).
The format of this parameter is as follows:
[Account]
FORMAT Account_Index = Account_ServedTrunkGroup,
Account_ServedIPGroup, Account_ServingIPGroup,
Account_Username, Account_Password, Account_HostName,
Account_Register, Account_ContactUser, Account_ApplicationType;