Version 6.4 705 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
For example:
CauseMapISDN2SIP 0 = 50,480;
CauseMapISDN2SIP 0 = 6,406;
When a Release Cause is received (from the PSTN side), the
device searches this mapping table for a match. If the Q.850
Release Cause is found, the SIP response assigned to it is sent
to the IP side. If no match is found, the default static mapping is
used.
Notes:
This parameter can appear up to 12 times.
For configuring ini file table parameters, see 'Configuring ini
File Table Parameters' on page 84.
Release Cause Mapping from SIP to ISDN Table
Web: Release Cause Mapping
Table
EMS: SIP to ISDN Cause Mapping
[CauseMapSIP2ISDN]
This parameter table maps SIP responses to Q.850 Release
Causes. The format of this parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_Index =
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause;
[\CauseMapSIP2ISDN]
Where,
SipResponse = SIP Response
IsdnReleaseCause = Q.850 Release Cause
For example:
CauseMapSIP2ISDN 0 = 480,50;
CauseMapSIP2ISDN 0 = 404,3;
When a SIP response is received (from the IP side), the device
searches this mapping table for a match. If the SIP response is
found, the Q.850 Release Cause assigned to it is sent to the
PSTN. If no match is found, the default static mapping is used.
Notes:
This parameter can appear up to 12 times.
For configuring ini file table parameters, see 'Configuring ini
File Table Parameters' on page 84.
Web/EMS: Enable Calling Party
Category
[EnableCallingPartyCategory]
Determines whether Calling Party Category (CPC) is mapped
between SIP and PRI.
[0] Disable = Don't relay the CPC between SIP and PRI
(default).
[1] Enable = The CPC is relayed between SIP and PRI.
If enabled, the CPC received in the Originating Line Information
(OLI) IE of an incoming ISDN Setup message is relayed to the
From/P-Asserted-Identity headers using the 'cpc' parameter in
the outgoing INVITE message, and vice versa.
For example (calling party is a payphone):
From:<sip:2000;cpc=payphone@10.8.23.70>;tag=1c18061574
51
Note: This feature is applicable only to the NI-2 PRI variant.
[UserToUserHeaderFormat]
Determines the format of the User-to-User SIP header in the
INVITE message for interworking the ISDN User to User (UU)
IE data to SIP.
To Next Page
Loading...
