AudioCodes Mediant 600 - Page 706

SIP User's Manual 706 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description

[0] = Format: X-UserToUser (default).
 [1] = Format: User-to-User with Protocol Discriminator (pd)
attribute.
User-to-
User=3030373435313734313635353b313233343b3834;pd
=4. (This format is according to IETF Internet-Draft draft-
johnston-sipping-cc-uui-04.)
 [2] = Format: User-to-User with encoding=hex at the end
and pd embedded as the first byte.
User-to-
User=043030373435313734313635353b313233343b3834;
encoding=hex. Where "04" at the beginning of this message
is the pd. (This format is according to IETF Internet-Draft
draft-johnston-sipping-cc-uui-03.)
Web/EMS: Remove CLI when
Restricted
[RemoveCLIWhenRestricted]
Determines (for IP-to-Tel calls) whether the Calling Number
and Calling Name IEs are removed from the ISDN Setup
message if the presentation is set to Restricted.
 [0] No = IE's are not removed (default).
 [1] Yes = IE's are removed.
Web/EMS: Remove Calling Name
[RemoveCallingName]
Enables the device to remove the Calling Name from SIP-to-
ISDN calls for all trunks.
 [0] Disable = Does not remove Calling Name (default).
 [1] Enable = Removes Calling Name.
Web: Remove Calling Name
EMS: Remove Calling Name For
Trunk Mode
[RemoveCallingNameForTrunk_x
]
Enables the device to remove the Calling Name per trunk
(where x denotes the trunk number) for SIP-to-ISDN calls.
 [-1] Use Global Parameter = Settings of the global
parameter RemoveCallingName are used (default).
 [0] Disable = Does not remove Calling Name.
 [1] Enable = Remove Calling Name.
Web/EMS: Progress Indicator to
ISDN
[ProgressIndicator2ISDN_ID]
Determines the Progress Indicator (PI) to ISDN. The ID in the
ini file parameter denotes the trunk number, where 0 is the first
trunk.
 [-1] Not Configured = The PI in ISDN messages is set
according to the parameter PlayRBTone2Tel (default).
 [0] No PI = PI is not sent to ISDN.
 [1] PI = 1; [8] PI = 8: The PI value is sent to PSTN in
Q.931/Proceeding and Alerting messages. Typically, the
PSTN/PBX cuts through the audio channel without playing
local Ringback tone, enabling the originating party to hear
remote Call Progress Tones or network announcements.
Web: Set PI in Rx Disconnect
Message
EMS: Set PI For Disconnect Msg
[PIForDisconnectMsg_ID]
Defines the device's behavior when a Disconnect message is
received from the ISDN before a Connect message is received.
The ID in the ini file parameter denotes the trunk number,
where 0 is the first trunk.
 [-1] Not Configured = Sends a 183 SIP response according
to the received progress indicator (PI) in the ISDN
Disconnect message. If PI = 1 or 8, the device sends a 183
response, enabling the PSTN to play a voice announcement
to the IP side. If there isn't a PI in the Disconnect message,
the call is released (default).
 [0] No PI = Doesn't send a 183 response to IP. The call is
released.