AudioCodes Mediant 600 - Page 751

Version 6.4 751 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
Use EndPoint Number As Calling
Number Tel2IP
[UseEPNumAsCallingNumTel2IP
]
Enables the use of the B-channel number as the calling number
(sent in the From field of the INVITE) instead of the number
received in the Q.931 Setup message, for Tel-to-IP calls.
 [0] Disable (default)
 [1] Enable
For example, if the incoming calling party number in the Q.931
Setup message is "12345" and the B-channel number is 17,
then the outgoing INVITE From header is set to "17" instead of
"12345".
Note: When enabled, this feature is applied before routing and
manipulation on the source number.
Use EndPoint Number As Calling
Number IP2Tel
[UseEPNumAsCallingNumIP2Tel
]
Enables the use of the B-channel number as the calling party
number (sent in the Q.931 Setup message) instead of the
number received in the From header of the INVITE, for IP-to-Tel
calls.
 [0] Disable (default)
 [1] Enable
For example, if the incoming INVITE From header contains
"12345" and the destined B-channel number is 17, then the
outgoing calling party number in the Q.931 Setup message is
set to "17" instead of "12345".
Note: When enabled, this feature is applied after routing and
manipulation on the source number (i.e., just before sending to
the Tel side).
Web: Tel2IP Default Redirect
Reason
[Tel2IPDefaultRedirectReason]
Determines the default redirect reason for Tel-to-IP calls when
no redirect reason (or “unknown”) exists in the received Q931
ISDN Setup message. The device includes this default redirect
reason in the SIP History-Info header of the outgoing INVITE.
If a redirect reason exists in the received Setup message, this
parameter is ignored and the device sends the INVITE message
with the reason according to the received Setup message. If this
parameter is not configured (-1), the outgoing INVITE is sent
with the redirect reason as received in the Setup message (if
none or “unknown” reason, then without a reason).
 [-1] Not Configured (default) = Received redirect reason is
not changed
 [1] Busy = Call forwarding busy
 [2] No Reply = Call forwarding no reply
 [9] DTE Out of Order = Call forwarding DTE out of order
 [10] Deflection = Call deflection
 [15] Systematic/Unconditional = Call forward unconditional
Web: Set Redirect number
Screening Indicator to TEL
EMS: Set IP To Tel Redirect
Screening Indicator
[SetIp2TelRedirectScreeningInd]
Determines the value of the Redirect Number screening
indicator in ISDN Setup messages.
 [-1] Not Configured (default)
 [0] User Provided
 [1] User Passed
 [2] User Failed
 [3] Network Provided
Note: This parameter is applicable only to digital PSTN
interfaces (ISDN).