AudioCodes Mediant 600 - Page 752

SIP User's Manual 752 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
Web: Set IP-to-TEL Redirect
Reason
[SetIp2TelRedirectReason]
Defines the redirect reason for IP-to-Tel calls. If redirect
(diversion) information is received from the IP, the redirect
reason is set to the value of this parameter before the device
sends it on to the Tel.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Note: This parameter is applicable only to digital PSTN
interfaces (ISDN).
Web: Set TEL-to-IP Redirect
Reason
[SetTel2IpRedirectReason]
Defines the redirect reason for Tel-to-IP calls. If redirect
(diversion) information is received from the Tel, the redirect
reason is set to the value of this parameter before the device
sends it on to the IP.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Note: This parameter is applicable only to digital PSTN
interfaces (ISDN).
Web: Send Screening Indicator to
IP
EMS: Screening Indicator To IP
[ScreeningInd2IP]
Overrides the calling party's number (CPN) screening indication
in the received ISDN SETUP message for Tel-to-IP calls.
 [-1] Not Configured = not configured (interworking from ISDN
to IP) or set to 0 for CAS (default).
 [0] User Provided = CPN set by user, but not screened
(verified).
 [1] User Passed = CPN set by user, verified and passed.
 [2] User Failed = CPN set by user, and verification failed.
 [3] Network Provided = CPN set by network.
Note: This parameter is applicable only if the Remote Party ID
(RPID) header is enabled.