AudioCodes Mediant 600 - Page 758

SIP User's Manual 758 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description

'*' (asterisk): represents any number between 0 and 255.
For example, 10.8.8.* represents addresses between
10.8.8.0 and 10.8.8.255.
 The following parameteris not applicable:
IsPresentationRestricted.
 To configure manipulation of destination numbers for IP-to-
Tel calls using the Web interface, see 'Configuring Number
Manipulation Tables' on page 256).
 For a description on using ini file table parameters, see
'Configuring ini File Table Parameters' on page 84.
[PerformAdditionalIP2TELDestin
ationManipulation]
Enables additional destination number manipulation for IP-to-
Tel calls. The additional manipulation is done on the initially
manipulated destination number, and this additional rule is also
configured in the manipulation table (NumberMapIP2Tel
parameter). This enables you to configure only a few
manipulation rules for complex number manipulation
requirements (that generally require many rules).
 [0] = Disable (default)
 [1] = Enable
Destination Phone Number Manipulation for Tel-to-IP Calls Table
Web: Destination Phone Number
Manipulation Table for Tel > IP
Calls
EMS: SIP Manipulations >
Destination Telcom to IPs
[NumberMapTel2IP]
This parameter table manipulates the destination number of Tel-
to-IP calls. The format of this parameter is as follows:
[NumberMapTel2Ip]
FORMAT NumberMapTel2Ip_Index =
NumberMapTel2Ip_DestinationPrefix,
NumberMapTel2Ip_SourcePrefix,
NumberMapTel2Ip_SourceAddress,
NumberMapTel2Ip_NumberType,
NumberMapTel2Ip_NumberPlan,
NumberMapTel2Ip_RemoveFromLeft,
NumberMapTel2Ip_RemoveFromRight,
NumberMapTel2Ip_LeaveFromRight,
NumberMapTel2Ip_Prefix2Add, NumberMapTel2Ip_Suffix2Add,
NumberMapTel2Ip_IsPresentationRestricted,
NumberMapTel2Ip_SrcTrunkGroupID, NumberMapTel2Ip_
SrcIPGroupID;
[\NumberMapTel2Ip]
For example:
NumberMapTel2Ip 0 = 01,$$,*,0,0,2,$$,$$,971,$$,$$,$$,$$;
NumberMapTel2Ip 1 = 10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
Notes:
 This table parameter can include up to 120 indices (0-119).
 The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight,
Prefix2Add, and then Suffix2Add.
 If the called and calling numbers match the DestinationPrefix
and/or SourcePrefix conditions, then the parameters
NumberType, NumberPlan, RemoveFromLeft,
RemoveFromRight, Prefix2Add, Suffix2Add, and/or
LeaveFromRight are applied.
 Number Plan and Type can be used in the Remote-Party-ID
header by configuring the EnableRPIHeader and
AddTON2RPI parameters.