AudioCodes Mediant 600 - Page 759

Version 6.4 759 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description

The following parameters are not applicable:
SourceAddress and IsPresentationRestricted.
 To configure manipulation of destination numbers for Tel-to-
IP calls using the Web interface, see 'Configuring the
Number Manipulation Tables' on page 256).
 For a description on using ini file table parameters, see
'Configuring ini File Table Parameters' on page 84.
Source Phone Number Manipulation for IP-to-Tel Calls Table
Web: Source Phone Number
Manipulation Table for IP > Tel
Calls
EMS: EMS: SIP Manipulations >
Source IP to Telcom
[SourceNumberMapIP2Tel]
This parameter table manipulates the source number for IP-to-
Tel calls. The format of this parameter is as follows:
[SourceNumberMapIp2Tel]
FORMAT SourceNumberMapIp2Tel_Index =
SourceNumberMapIp2Tel_DestinationPrefix,
SourceNumberMapIp2Tel_SourcePrefix,
SourceNumberMapIp2Tel_SourceAddress,
SourceNumberMapIp2Tel_NumberType,
SourceNumberMapIp2Tel_NumberPlan,
SourceNumberMapIp2Tel_RemoveFromLeft,
SourceNumberMapIp2Tel_RemoveFromRight,
SourceNumberMapIp2Tel_LeaveFromRight,
SourceNumberMapIp2Tel_Prefix2Add,
SourceNumberMapIp2Tel_Suffix2Add,
SourceNumberMapIp2Tel_IsPresentationRestricted;
[\SourceNumberMapIp2Tel]
For example:
SourceNumberMapIp2Tel 0 = 22,03,$$,$$,$$,$$,2,667,$$,$$;
SourceNumberMapIp2Tel 1 =
034,01,1.1.1.1,$$,0,2,$$,$$,972,$$,10;
Notes:
 This table parameter can include up to 120 indices.
 The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight,
Prefix2Add, and then Suffix2Add.
 If the called and calling numbers match the
DestinationPrefix, SourcePrefix, and/or SourceAddress
conditions, then the RemoveFromLeft, RemoveFromRight,
Prefix2Add, Suffix2Add, LeaveFromRight, NumberType,
and/or NumberPlan are applied.

'x': represents single digits. For example: 10.8.8.xx
represents addresses between 10.8.8.10 and 10.8.8.99.

'*' (asterisk): represents any number between 0 and 255.
For example, 10.8.8.* represents addresses between
10.8.8.0 and 10.8.8.255.
 To configure manipulation of source numbers for IP-to-Tel
calls using the Web interface, see 'Configuring Number
Manipulation Tables' on page 256).
 For a description on using ini file table parameters, see
'Configuring ini File Table Parameters' on page 84.
[PerformAdditionalIP2TELSourc
eManipulation]
Enables additional source number manipulation for IP-to-Tel
calls. The additional manipulation is done on the initially
manipulated source number, and this additional rule is also
configured in the manipulation table (SourceNumberMapIP2Tel