AudioCodes Mediant 600 - Page 772

SIP User's Manual 772 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
The valid value can be up to 16 characters. The default is
"callingnumber".
Note: The APS server support must be enabled to support this
feature. Below are the relevant ini file parameter settings:
 CallingNumberPlayBackID = callingnumber
 VpFileUrl = 'http://10.132.10.46/vp.dat'
 APSSegmentsFileURL = 'http://10.132.10.46/segments.xml'
 APSEnabled = 1
 AMSProfile = 1
 AASPackagesProfile = 3
 EnableVoiceStreaming = 1
Web: NetAnn Announcement
ID
[NetAnnAnncID]
Defines the NetAnn identification string (up to 16 characters) for
playing an announcement using the NetAnn interface. The
application server sends a regular SIP INVITE message with a SIP
URI that includes this identifier string and a “play=” parameter that
identifies the necessary announcement.
The default value is ‘annc’.
Example 1: INVITE sip: annc@10.2.3.4;play=http://localhost/1.
Example 2: INVITE sip:
annc@10.2.3.4;play=http://10.2.3.4/Annc/hello.wav.
Web: MSCML ID
[MSCMLID]
Defines the Media Server Control Markup Language (MSCML)
identification string (up to 16 characters). To start an MSCML
session, the application server sends a regular SIP INVITE message
with a SIP URI that includes this string.
The default value is ‘ivr’.
For example: INVITE sip:ivr@10.2.3.4
Subsequent INFO messages carry the requests and responses.
Web: Transcoding ID
[TranscodingID]
Defines the Transcoding identification string (up to 16 characters)
used for identifying an incoming Transcoding call.
The default value is ‘trans’.
For more information on Transcoding, see NetAnn Interface on page
426.
AMS Parameters
[AmsProfile]
Enables advanced audio.
 [0] = Disable (default)
 [1] = Enable
Note: For this parameter to take effect, a device reset is required.
[AASPackagesProfile]
Must be set to 3 to use advanced audio.
Note: For this parameter to take effect, a device reset is required.
[AmsPrimaryLanguage]
Determines the primary language used in the advanced audio
package.
The default value is “eng”.
The languages are according to ISO standard 639-2 language
codes.
[AmsSecondaryLanguage]
Determines the secondary language used in the advanced audio
package.
The default value is “heb”.
The languages are according to ISO standard 639-2 language
codes.