Belarus 82.3 - Page 15

82.3-0000010 OM
15
Table 1.2.1 finished
Parameter
(characteristics) title
Parameter value for the tractor
“BELARUS-82.3”
19 Hydraulic system:
а) pump displacement under crankshaft
rated speed, l/min, not less than
46
b) safety valve activation pressure, MPa
20
-2
c) conventional volume factor, not less
than
0.65
20 Working equipment:
а) rear power take-off shaft:
1) rated speed of PTO shaft end with
the continuous drive engaged, rpm:
- position I (under the engine crankshaft
speed of 2080 rpm)
540
- position II (under the engine crankshaft
speed of 2200 rpm)
955
2) rated speed of PTO shaft end with
the ground-speed drive on, rev/meter of
travel:
3.36
(on rear tires of standard configuration
(18.4R34))
b) rear lift linkage:
1) loading capacity of rear lift linkage on
suspension axis, kg, not less than
3200
2) time for raising rear lift linkage from
lowermost position into uppermost position
with test load on suspension axis, seconds,
not more than
≈3
c) tow hitch:
In Section 4 “Coupling of implements”
_____________________________________________________________________________________________________________
1)
Engine parameters, not specified in the table 1.2.1, shall meet documentation
243 – 0000100 OM.
2)
For referential use.
3)
With ballast weights mounted.
Note - All information given both in table 1.2.1 and further in this manual refers to
the tractor equipped with FDA with planetary-spur wheel gear groups (basic configuration).
Limited batches of tractors BELARUS-82.3 can be equipped with FDA with taper-type
wheel gear groups upon an order. For information on tires used, track setting of tractor
with taper gear groups, as well as maintenance of taper reduction gear, please contact
your dealer.