Belarus 82.3 - Fuses for the Electrical Socket Block

82.3-0000010 OM
57
Fuses for electronic control systems (ECS) are shown in Figure 2.17.8.
Figure 2.17.8 – Fuses for electronic control systems
Four cut-out fuses (Figure 2.17.8) protect the following electrical circuits from over-
loads:
1 – PTO drive control (7.5 А);
2 – DL real axle control (7,5 А);
3 – RPTO control (7,5 А);
4 – Reserve (7,5 А);
5 – Seat pneumatic compressor, if a pneumatic seat is installed on request (15A);
6 – Reserve (7,5 A);
2.17.4 Fuses for the electrical socket block
Electrical sockets 2, 3 (Figure 2.21.2) are installed on the side panel.
Electrical sockets 2, 3 are protected by fuses. The socket 2 (Figure 2.21.2) is pro-
tected by a pendant fuse 3 (Figure 2.17.9) of 30 A rating. Socket 3 (Figure 2.21.2) is pro-
tected by a pendant fuse 1 (Figure 2.17.9) of 20 A rating.
1 – 20 A pendant fuse; 2 – HLL and HSC oil tank; 3 – 30 A pendant fuse;
Figure 2.17.9 – Fuses for electrical sockets block