Belarus 82.3 - Maintenance Procedure

82.3-0000010 OM
156
5.3 Maintenance procedure
Contents of scheduled maintenance for the BELARUS-82.3 tractor in course of operation
are listed in Table 5.3.1.
Table 5.3.1
Operatio
n No
Operation description
Periodicity, h
8-10
125
250
500
1000
2000
1
Check the oil level in the crankcase
X
2
Clean the alternator
X
3
Check transmission oil level
X
4
Check oil level in the conjoint tank of the HLL
and HSC
X
5
Check coolant level in the engine cooling system
X
6
Check tire condition
X
7
Inspect elements of the hydraulic system. Check
condition of harnesses and wires of electrical
equipment in the engine compartment, in the
area of
the cab front wall and visible parts of the
electrical wiring
X
8
Check A/C hoses. Check/clean air conditioner
drain tubes
X
9
Remove condensate from the pneumatic system
tank
X
10
Check operation of brakes in motion, perfor-
mance of engine, steering, lighting and alarm
X
11
1)
Check wheel bolts for tightness
X
X
12
2)
Check/clean A/C condenser and engine water
cooler
X
13
2) 3)
Check / wash RLL grippers
X
14
2)
Wash the tractor and clean cab interior
X
15
4)
Check air pressure in tires
X
16
Drain sediment from fuel tanks
X
17
Drain sediment from coarse fuel filter
X
18
2)
Clean filter elements of the cabin ventilation and
heating system filter
X
19
5)
Check level and condition of oil in the engine air
cleaner sump
X
20
Check/adjust fan belt tension
X
21
Check/adjust tension of A/C compressor drive
belt
X
22
6)
Carry out battery maintenance
X
23
7)
Lubricate the HSC hydraulic cylinder pivots
X
24
Check/adjust play in steering joints
X
25
Check/adjust front wheel toe-in
X
26
7)
Lubricate clutch release bearing
X
27
7)
Lubricate the axle bearings of FDA pivots
X
28
Change engine oil filter
X
29
Change oil in engine crankcase
X