82.3-0000010 OM
107
4.4 Tow hitches
4.4.1 General information
The BELARUS-82.3 tractor can be equipped with the following elements of the tow
hitches: a non-rotating yoke, a long non-automatic rotating yoke with a 30mm diameter
kingpin in accordance with GOST 32774, a non-automatic rotating yoke in accordance with
GOST 32774 and ISO 6489-2, an automatic rotating yoke according to ISO 6489-2, a PI-
TON-type element according to ISO 6489-4, a non-standard PITON-type element, a draw
bar of category 2 according to ISO 6489-3, a draw bar of category 2 according to GOST
32774, a draw bar according to STB 2028, a tow hook, a cross-bar, a twin cross-bar.
The listed tow hitches ensure the connection and transportation of trailers, semi-
trailers, trailed and semi-trailed machines, the parameters of which meet the requirements
specified in the tables of this section, and the trailing appliances of which ensure compati-
bility with connection dimensions.
The rear mating surface of the rear axle body has a bracket attached, which has
vertical guide grooves with a number of holes. This bracket provides fastening in various
height positions of such elements as yokes and PITON-type elements, as well as fastening
of a draw bar or a tow hook.
Installation variant scheme of non-rotating yoke 1321-2707111-A is shown in figure 4.4.1.
Installation variant scheme of non-rotating yoke 1321-2707113-A is shown in figure 4.4.2.
Installation scheme of non-automatic rotating yoke under GOST 32774 and ISO
6489-2 is shown in figure 4.4.3.
Installation variant scheme of long non-automatic rotating yoke with a 30mm diame-
ter kingpin is shown in figure 4.4.4.
Installation variant scheme of automatic rotating yoke under ISO 6489-2 is shown in
figure 4.4.5.
Installation scheme of non-standard PITON-type element is shown in figure 4.4.7.
Installation scheme of PITON-type element under ISO 6489-4 is shown in
figure 4.4.8.
Installation scheme of draw bars of category 2 under ISO 6489-3 and GOST 32774
is shown in figure 4.4.10.
Installation scheme of draw bar under STB 2028 is shown in figure 4.4.11.
Tow hook with control elements is shown in figure 4.4.12.
Twin cross-bar is shown in figure 4.4.13.
Cross-bar is shown in figure 4.4.14.
ATTENTION: THE POSSIBILITY OF USING A SPECIFIC TOW HITCH DEPEND-
ING ON ITS TYPE AND DESIGN CAN BE LIMITED TO THE LAWS AND REGULA-
TIONS, APPLICABLE IN THE TERRITORY OF THE COUNTRY WHERE THE TRACTOR
IS USED!
ATTENTION: DO NOT USE THE TOW HITCH AS A FOOTSTEP!
ATTENTION: VERTICAL LOAD AT THE HITCH POINT MUST NOT BE DIRECTED UP!
ATTENTION: HEIGHT ABOVE THE GROUND OF A TRAILING APPLIANCE OF A
TRAILER, SEMI-TRAILER OR THE MACHINE MUST BE EQUAL TO THE HEIGHT
ABOVE THE GROUND OF THE RESPECTIVE ELEMENT OF THE TRACTOR TOW
HITCH SO THAT THE EYELET IS ARRANGED HORIZONTALLY WITH A PERMISSIBLE
DEVIATION ± 3°, WHEN THE TRACTOR, AS WELL AS THE TRAILER, SEMI-TRAILER
OR MACHINE ARE LOCATED ON A HORIZONTAL SURFACE!
To Next Page
