82.3-0000010 OM
28
2.6.2.3. Numbers “0”, “1/2” and “1” are marked on the gauge to indicate fuel volume
in the tank 7 (Figure 2.6.1).
The input signal for the gauge to indicate fuel volume in the tank 7 is the signal from
frequency sensor. In case the signal from frequency fuel volume sensor is missing, the
needle indicator of the fuel volume sensor 7 is at the start of the scale (on the point of the
scale) while the annunciator of low fuel volume 8 turns on simultaneously.
2.6.2.4. Numbers “40”, “80”, “105” and “120” are marked on the gauge to indicate
coolant temperature 12 (Figure 2.6.1).
2.6.3 Instrument panel annunciators
Annunciator 2 (Figure 2.6.1) is the annunciator of tractor left turn indicator actuation
(green) which operates in flashing mode when the left turn indicator is activated with the
multifunctional steering column switch 3 (Figure2.2.1), or when the emergency flashing
switch 2 is activated.
Annunciator 4 (Figure 2.6.1) is the annunciator of tractor right turn indicator actua-
tion (green) which operates in flashing mode when the right turn indicator is activated with
the multifunctional steering column switch 3 (Figure 2.2.1), or when the emergency flash-
ing switch 2 is activated.
Annunciator 8 (Figure 2.6.1) is the annunciator of low fuel volume (orange) which is
actuated in constant mode when the fuel volume in the tank decreases to 1/8 from the total
tank volume, as well as when the signal from fuel level sensor installed in the tank is miss-
ing.
ATTENTION: DO NOT LET THE TANK BECOME EMPTY (THE GAUGE NEEDLE
IS IN THE ORANGE ZONE)!
Annunciator 9 (Figure 2.6.1) is the annunciator of reverse gears engagement
(green), which is not is use on tractors BELARUS-82.3.
Annunciator 10 (Figure 2.6.1) is the annunciator of forward gears engagement
(green), which is not is use on tractors BELARUS-82.3.
Annunciator 11 (Figure 2.6.1) is the annunciator of coolant emergency temperature
(red) which is actuated in constant mode when the coolant temperature exceeds the per-
missible level (≈105 °С and higher).
Annunciators 13 (Figure 2.6.1) built in the engine crankshaft speed gauge 1 are
presented in Figure 2.6.2 and in table 2.6.1.