Belarus 82.3 - Possibility of Front Loader Installation; General Information

82.3-0000010 OM
147
4.13 Possibility of front loader installation
4.13.1 General information
When choosing, buying and mounting of front loaders (hereinafter referred to as
loaders) pay attention to requirements specified in the present tractor operation manual
and in Table 4.13.1.
Table 4.13.1 – Rules on the use of the BELARUS-82.3 tractors with loader
Name of parameter (characteristics) Indicator (characteristics) value
Standard size of tractor wheel tires at which
installation of loader is possible
360/70R24 – front, 18,4R34 – rear
(i.e. basic configuration tires or similar imported
tires)
Tractor wheel tire pressure
Inner pressure in wheel tires shall be set as for
the speed of 30 km/h
Tractor wheel track, m:
- for front wheels, not less
- for front wheels
1800
2100
Tractor axle permissible load (with regard to
tractor and loader weights), kN, maximum:
- for front axle;
- for rear axle
37.0
53.0
Tractor weight with loader, kg, not more than
7000
Push force in cutting mode, kN, not more
than
18.0
Overloading protection while in cutting mode
Automated protection in loader design
Speed of tractor movement with loader in-
stalled, km/h, not more than:
- operation speed with load
- operation speed without load
- traveling speed
6
12
20
Tractor ballasting with loader installed (when
necessary)
1. Ballast weight – on rear lift linkage.
2. Water solution in rear tires
Places of loader fastening to a tractor:
- loader mounting frame
Front beam, frame rails, coupling clutch case
- loader push rods
Tubes of semi-axles, GB casing and rear axle
Shift-time monitoring
(controllable parameters, in addition to STM
operations, listed in tractor and loader opera-
tion manuals)
1. Tightness of fasteners of loader mounting
frame and tractor wheels.
2. Tractor tire inflation pressure
Connection of loader hydraulic system
Tractor hydraulic outputs
Recommended pressure of safety valve ad-
justment (when an independent hydraulic dis-
tributor
in a loader set is available) of the
loader hydraulic system, MPa, maximum
17.0
ATTENTION: THE LOADER’S BEARING CAPACITY DEPENDS ON OVERHANG
AND DESIGN OF LOADER WORKING ATTACHMENTS, AND SPECIFICATIONS OF
LIFTED LOAD!
IT IS FORBIDDEN TO USE THE LOADER ON A TRACTOR HAVING NO CAB OR
CANOPY FRAME; HAVING NO SYSTEM OF NOT-WILLED MOVEMENT LIMITATION
(SEAT BELTS), AND ALSO IN CONFIGURATION WITH FRONT AND REAR TIRES OF
IRREGULAR (NON-BASIC) CONFIGURATION.