Belarus 82.3 - Page 38

82.3-0000010 OM
38
Table 2.6.6 – Heating plug operation time depending on engine temperature
Engine
temperature, °С
Time of engine pre-start
heating, sec.
Time of heating after en-
gine start-up, sec.
more than plus 30
0
0
from plus 20 to plus 30
≈14
≈45
from 0 to plus 20
≈20
≈74
from minus 20 to 0
≈33
≈183
from minus 50 to minus 20
≈50
≈183
The list of light codes displayed by the HP annunciator when indicating failures in
the HP system is given in Table 2.6.7.
Table 2.6.7 - light codes indicating failures in the HP or HP controller
Light
code
Description
Light
code
Description
Heating plug failure (Disconnection or
short circuit)
Power switch failure
(power switch breakdown)
11
Plug 1 is out of order
12
Channel 1 switch failure
21
Plug 2 is out of order
22
Channel 2 switch failure
31
Plug 3 is out of order
32
Channel 3 switch failure
41
Plug 4 is out of order
42
Channel 4 switch failure
Note to table 2.6.7: in case of a fault in the circuit of one of the heating plugs or
breakdown of the power switch, a series of double flashes follows which indicate the fail-
ure codes. For example, if one heating plug annunciator flashes for about 0.25 second fol-
lowed by two flashes lasting about 0.25 second each and with intervals of about one sec-
ond, the failure code will be 12. If there are two or more failures, the codes shall be dis-
played sequentially.