82.3-0000010 OM
68
- after the annunciator of HP operation goes out, start the engine by depressing the
clutch pedal and turning the key of starter and instruments switch from position "I" (instru-
ments on) to position "II" (engine start);
- hold the key of the starter switch turned until the engine is started but not longer
than 20 seconds; if the engine has not started, a repeated start-up shall be carried out not
earlier than one minute later;
- after the engine is started, release the clutch pedal, check function of all annuncia-
tors and indications of the indicator panel (coolant temperature, oil pressure in the engine
and transmission, on-board circuit voltage, etc.). Let the engine run at low rpm until pres-
sure stabilizes within operation range. The instrument panel displays the actually meas-
ured parameters and conditions of the tractor units and systems operation.
IT IS FORBIDDEN TO OPERATE THE TRACTOR IN CLOSED ROOMS WITHOUT
PROPER VENTILATION (AIR EXCHANGE). EXHAUST GASES MAY BE LETHAL!
IT IS FORBIDDEN TO RUN THE ENGINE WITH THE SYSTEMS OF ENGINE
COOLING AND LUBRICATION UNFILLED!
ATTENTION: THE TRACTOR CAB IS EQUIPPED WITH A SINGLE SEAT AND
THE OPERATOR IS THE ONLY PERSON TO STAY IN!
ATTENTION: START THE ENGINE AND PERFORM INSTRUMENT CONTROL
OPERATIONS ONLY WHILE STAYING IN THE OPERATOR'S SEAT!
NOTE: REMEMBER THAT THE ENGINE CAN ONLY BE STARTED WHEN THE
GB GEAR SHIFTING LEVER IS IN NEUTRAL POSITION!
ATTENTION: THERE SHALL BE NO PEOPLE UNDER, BEFORE AND BEHIND THE
TRACTOR, AND BETWEEN THE TRACTOR AND AN IMPLEMENT COUPLED TO IT!
To Next Page
Loading...
