82.3-0000010 OM
86
Do not operate the tractor with control-gauging instruments out of order.
It is not allowed to inflate tires without pressure control.
When coupling the tractor with agricultural implements, comply additionally with
safety measures concerning the use of these implements.
Before coupling the tractor with agricultural implements, make sure the automatic grips
of the lower and upper links of the RLL are clean and faultless. It is forbidden to operate with
the automatic grips out of order, their inner cavities stuffed with dirt and foreign particles.
If the tractor front part rises off the ground when heavy implements are hinged on
the mechanism of the rear lift linkage, mount front ballast weights.
Do not work under raised agricultural implements. Do not leave implements uplifted
when stopping for a long time.
Before raising and lowering a mounted agricultural implement and also when turn-
ing the tractor, make sure there is no danger of hitting a person or a hurdle.
The mounted and semi-mounted machine is to be lowered into its operating position
and raised into the hauling position only with a straight-line motion of the assembly unit.
To avoid breakdown of the tractor or the agricultural implement, transportation and
turns of the tractor assembly with the agricultural implement raised shall be carried out on-
ly after you make sure the rear PTO is disengaged.
When hinging or coupling the agricultural machines and implements on the tractor,
the rear operator shall stay at a safe distance until the operation is fully stopped. The hing-
ing (coupling) shall be started only after the tractor operator gives a command.
When linking the machine cardan shaft to the rear PTO, disengage the rear PTO,
stop the tractor by means of the parking brake and stop the engine.
After disconnecting the machines driven by the rear PTO, remove cardan drive and
cover the PTO end extension with protective cap.
Cardan shafts, that transf torque from the RPTO of the tractor to the implement
working units, shall be safeguarded.
When operating with stationary machines driven by the RPTO, always engage the
parking brake and lock the rear wheels at the front and at the back. Make sure the ma-
chine is securely fixed.
Make sure the safeguards of the RPTO are mounted and, if the PTO is not used,
put back the cap of the PTO shaft end extension.
Do not wear loose clothes when working with the RPTO or near rotating equipment.
To avoid breakdown of the tractor or the agricultural machine, turning the tractor as-
sembly is allowed only after the working units of the machine have been fully shallowed up
from the soil.
When the tractor assemblies are operating in a column, they shall have an interval
not less than 30 m between each other.
Depending on operation conditions, use natural ventilation of the cab or the unit of
air cooling and heating.
During tractor operation, the operator shall use regular hearing protection.
The tractor design does not provide lightning strike protection. Tractor operation
during thunderstorm is prohibited. Do not approach the tractor and equipment during thun-
derstorm, find a solid protected shelter. If a thunderstorm starts during tractor operation, do
not leave the cab. Do not touch anything outside the tractor cab.
In case the tractor assembly is operated or is driven in an area of power transmis-
sion lines, the distance between the top of the tractor assembly and wires shall conform to
Table 3.3.1.
Table 3.3.1
Horizontal distance, m, minimum
Vertical distance, m, minimum
To Next Page
Loading...
