Belarus 82.3 - Page 9

82.3-0000010 OM
9
Introduction
This manual is designed for studying the structure, rules of operation and mainte-
nance of tractors “BELARUS-82.3”.
Scrutinize this manual, attached to your tractor. It will help you study the rules of
correct operation and maintenance.
Failure to follow this instruction can lead to operator's injury or a tractor breakdown,
or cause damage to the third parties.
Operation of a tractor, its maintenance and repair shall be carried out only by em-
ployees who are familiar with all of its parameters and specifications and informed about
necessary safety requirements to prevent casualties.
Due to constant improvement of the tractor, some changes, which are not depicted
in the present manual, can be introduced in the structure of certain units and parts.
Any arbitrary changes made by a consumer release the manufacturer from re-
sponsibility for possible further injuries to the operator and tractor breakdown. In addition, if
the consumer introduces any changes in the assembly units within the warranty period, the
tractor warranty will be automatically terminated.
Adopted abbreviations and conventional notations:
AB – accumulator battery;
RADL – rear axle differential lock;
DL – differential lock;
PTO – power take-off shaft;
PRS – power reception shaft;
HSC – hydrostatic steering control;
HLL – hydraulic lift linkage;
HS – hydraulic system;
FLM – fuel and lubrication materials;
STM – shift-time maintenance;
LOHE - liquid-and-oil heat exchanger;
RPTO – rear power take-off shaft;
SPTA – spare parts, tools and accessories;
RA – rear axle;
RLL – rear lift linkage;
GB – gearbox;
HPC – heating plugs controller
MTU – machine and tractor unit;
CC – coupling clutch;
LL – lift linkage;
FDA – front driving axle;
FDAD – front driving axle drive;
HPH – high pressure hoses;
HP – heating plugs;
DR – draft regulator
MS – maintenance service;
MS1 – maintenance service No1;
MS2 – maintenance service No2;
MS3 – maintenance service No3;
TH –tow hitch;
FC – filter cartridge;
ECS – electronic control system;
TECS – transmission electronic control system;
EE – electrical equipment.