Bosch Rexroth Tightening System 350 - Page 359

3 608 878 300 Tightening Technology | Bosch Rexroth AG 359/641
System 350 | 3 608 878 300/2019-03
Job batch mode OK and NOK tightening counting procedure.
– 0: Only OK tightenings are counted
– 1: OK and NOK tightenings are counted
If only the OK counter is assigned at all counter values, a "0" is returned.
Otherwise "1".
The value consists of one ASCII characters.
ID 06
2
Value range 0–1
Presetting -
Example:
Mode 1
Value 1
1
Disable counter value in job
after processing
–0: No
–1: Yes
As soon as "disable" is activated for all OK/NOK counter values, "1" is
reported.
The value consists of one ASCII characters.
ID 07
2
Value range 0–1
Presetting -
Example:
Disable job 1
Value 1
1
Line control Line control: not supported
The value consists of one ASCII characters.
ID 08
2
Fixed value 0
1
Repeat job Repeat job: not supported.
The value consists of one ASCII characters.
ID 09
2
Fixed value 0
1
Allow loosening – 0: Enable
–1: Disable
As soon as "loosen" is activated for an OK/NOK counter value, "0" is
reported.
The value consists of one ASCII characters.
ID 10
2
Value range 0–1
Presetting -
Example:
Allow loosening 0
Value 0
1
Reserved Reserved: not supported
The value consists of one ASCII characters.
ID 11
2
Fixed value 0
1
Table 6–88: MID 0033 revision 001
Parameter Comments Bytes