Bosch Rexroth Tightening System 350 - Page 361

3 608 878 300 Tightening Technology | Bosch Rexroth AG 361/641
System 350 | 3 608 878 300/2019-03
MID 0038 revision 002
6.7.7.7 Tool messages
MID 0040 Tool data upload request
MID 0041 Tool data upload
MID 0041 revision 001
Table 6–90: MID 0038 revision 002
Parameter Comments Bytes
Job number Job number 0-249
The value consists of four ASCII characters.
ID -
Value range 0000 – 9999
Presetting -
Example:
Job number 0001
Value 0001
4
Data length revision 002
4
Sent by: superordinate computer
The tool data (ErgoSpin, primary transducer for the tightening spindle) can be viewed using this function.
Note:
Is supported by Rexroth OP for the compact system (CS).
Revision: see MID 0041
Data field: is empty, 0 bytes
Possible response MID Error no. Comment
Tool data upload response 0041 –
Sent by: Tightening controller
Transfer of the tool data (ErgoSpin, primary transducer for the tightening spindle).
Note:
Is supported by Rexroth OP for the compact system (CS).
Revision: Number Supported by
001 Rexroth OP and Rexroth OP-Ford
002-1 Rexroth OP
002-2 Rexroth OP-Ford and Rexroth OP-BMW
Data field: Data 101 bytes
Possible response: none
Table 6–91: MID 0041 revision 001
Parameter Comments Bytes
Tool number – ErgoSpin: Serial number
– Tightening spindle: primary transducer serial number
The value consists of 14 ASCII characters.
ID 01
2
Value range 0x20 – 0x7F
Presetting -
Example:
Tool number A123456
Value A123456
14