Bosch Rexroth Tightening System 350 - Page 40

40/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
The following connections are on the outside of the device:
Fig. 3–6: Connections on the outside of the compact system CS351
The interfaces for input/output of signals for communication with partner controllers are accessible
behind the cover of the compact system housing. The cover of the CC-CS351E-D compact system is
blue.
Fig. 3–7: Possible interfaces on the CS351 compact system
X3U3 USB device interface, compatible with specification 2.0, with bolted-down cover
Q0 On/Off switch
X1N Power supply connection for 120 V/230 V
1
1 The Compact System CS351 is not designed to be directly connected to the public low-voltage power supply,
but is only intended for use in industrial environments (emission classA).
XDS1 Connection for ErgoSpin hand-held nutrunner
2
/CC-ErgoSpin
(only CS351E-G and CS351E-D, with/without IL, CS351E-G+, CS351E-D NK, CC-CS351E-D
2 Differences between the connections for ErgoSpin hand-held nutrunner (XDS1) and tightening spindle (XDS2)
can be found in the operating instructions"CS351".
XDS2 Connection for tightening spindle
2
(only CS351S-G and CS351S-D, with/without IL, CS351S-G+, CS351S-D NK
Q0
XDS1
X1N
X3U3
Q0
XDS2
X1N
X3U3
CS351E CS351S
1
17
9
1
24
C5
C4
C2
C3
C1
16
8
X7E1
X3U1
X3U2
XDN1
X6C1
X3C1
XDVI
X3U4
Reset
B2B1
A
NOKOK FG