Bosch Rexroth Tightening System 350 - Page 411

3 608 878 300 Tightening Technology | Bosch Rexroth AG 411/641
System 350 | 3 608 878 300/2019-03
MID 0113 Switch on green LED on ErgoSpin
Line 1 Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters.
ID 3
2
Value range 0x20 – 0x7F
Presetting -
Example:
Line 1 Title
Value Title
25
Line 2 Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters.
ID 4
2
Value range 0x20 – 0x7F
Presetting -
Example:
Line 2 Line 2
Value Line 2
25
Line 3 Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters.
ID 5
2
Value range 0x20 – 0x7F
Presetting -
Example:
Line 3 Line 3
Value Line 3
25
Line 4 Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters.
ID 6
2
Value range 0x20 – 0x7F
Presetting -
Example:
Line 4 Line 4
Value Line 4
25
Data length revision 001
117
Table 6–111: MID 0111 revision 001
Parameter Comments Bytes
Sent by: superordinate computer
The superior computer can switch on the green LED on the ErgoSpin by sending this message. The light on the
ErgoSpin will flash until the operator presses the start switch.
Note: -
Revision: 001 (supported by Rexroth OP and Rexroth OP-Ford and Rexroth OP-BMW)
Data field: is empty, 0 bytes
Possible response MID Error no. Comment
Command accepted 0005 –