Bosch Rexroth Tightening System 350 - Page 418

418/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
MID 0501 revision 002
MID 0502 Acknowledgement Upload output signal change
Table 6–115: MID 0501 revision 002
Parameter Comments Bytes
This revision outputs the values of the first 16 assignable output signals of the OP PLC module. The output is effected
in the order in which the signals have been stored by the user. The signals can be applied to the OP PLC module
from 1.0–2.7.
Signals ID none
Value range 0 (not active) or 1 (active)
Presetting -
Example:
Signals The signals can be assigned as desired.
Value 0010010000000001, e.g. AppOut0…AppOut15,
with:
–InCy=0
–Nok=0
–Ok=1
– AppOut3 = 0
– AppOut4 = 0
–CyCmp=1
– AppOut6 = 0
– AppOut7 = 0
– AppOut8 = 0
– AppOut9 = 0
– AppOut10 = 0
– AppOut11 = 0
– AppOut12 = 0
– AppOut13 = 0
– AppOut14 = 0
–CntOK=1
16
Data length revision 001
16
Sent by: superordinate computer
The superior computer acknowledges the change in the output signals (upload change in the output signals,
MID 0501).
Note: -
Revision:
001 (supported by Rexroth OP and Rexroth OP-Ford) and Rexroth OP-BMW)
Data field: is empty, 0 bytes
Possible response: none