Bosch Rexroth Tightening System 350 - Page 426

426/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
MID 0523 Cancel socket change
MID 0524 Select socket tray
MID 0524 revision 001
Sent by: superordinate computer
The subscription to the change in sockets (Logon socket change, MID 0520) is reset.
Note: -
Revision:
001 (supported by Rexroth OP and Rexroth OP-BMW)
Data field: is empty, 0 bytes
Possible response MID Error no. Comment
Command accepted 0005 –
Command error 0004 91 Activation for socket change not available
Sent by: superordinate computer
By means of this message, the individual LEDs at the socket tray for the worker guidance can be set or reset.
Note: In the PLC assignment table, the signals for the LEDs of the socket tray (BoxNut LED…) must be stored on
the OP PLC module.
Revision: 001 (supported by Rexroth OP and Rexroth OP-BMW)
Data field: Parameter IDs and parameter values, 24 bytes
Possible response MID Error no. Comment
Command accepted 0005 –
Command error 0004 65 Socket tray not configured
Table 6–120: MID 0524 revision 001
Parameter Comments Bytes
Tray 1 Defines the status of socket-LED 1.
ID 01
2
Value range – 0 (deactivated)
– 1 (activated)
Presetting -
Example:
Tray 1 deactivated
Value 0
1
Tray 2 Defines the status of socket-LED 2.
ID 02
2
Value range – 0 (deactivated)
– 1 (activated)
Presetting -
Example:
Tray 2 Activated
Value 1
1
Tray 3 Defines the status of socket-LED 3.
ID 03
2
Value range – 0 (deactivated)
– 1 (activated)
Presetting -
Example:
Tray 3 Activated
Value 1
1