Bosch Rexroth Tightening System 350 - Page 461

3 608 878 300 Tightening Technology | Bosch Rexroth AG 461/641
System 350 | 3 608 878 300/2019-03
Absolute angle Option – checked
– not checked
not checked If this option is selected, the
graph is converted into a
presentation raising
monotonously with the angle.
Step number List (expandable) – sequential
– Docu buffer
numbering
sequential Sets the step number for the
IPM data output
– sequential
Every docu step receives a
sequentially assigned
number (1…n), according to
the output order in the
tightening system.
The last tightened step
receives either the number
99 (final tightening step) or
the number 0 (no final
tightening step).
The information whether
there is a final tightening
step is buffered by the last
tightening position with OK
tightening of this AFO.
– Docu buffer numbering
As step number, the IPM
data output receives the
docu buffer number of the
tightening step.
If within one tightening step
without docu buffer attribute
there has been a
cancellation, the step
number will be given the
number 0.
Step category List (expandable) – End tightening
mode
– Step type
End tightening
mode
Sets the step category for the
IPM data output
– End tightening mode
Possible output values are
either "unknown" or "end
tightening".
"Final tightening" is only
output if the step number is
identical with the buffered
final tightening step number
of an OK tightening of this
AFO completed in advance.
– Step type
The number of the step type
of the tightening step of the
tightening system is
accepted without changes.
Step filter List (expandable) – Docu steps +
result step
– Result step
–All steps
Docu steps + result
step
Sets the tightening steps that
are transferred to the IPM
Step output order List (expandable) – sequential sequential Sets the order in which the
tightening steps are forwarded
to the IPM
Table 6–143: AFO default values in the view configuration Rexroth IPM Protocol
Element Type Value range Standard value Comment