464/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
Step number List (expandable) – sequential
– Docu buffer
numbering
sequential Sets the step number for the
IPM data output
– sequential
Every docu step receives a
sequentially assigned
number (1…n), according to
the output order in the
tightening system.
The last tightened step
receives either the number
99 (final tightening step) or
the number 0 (no final
tightening step).
The information whether
there is a final tightening
step is buffered by the last
tightening position with OK
tightening of this AFO.
– Docu buffer numbering
As step number, the IPM
data output receives the
docu buffer number of the
tightening step.
If within one tightening step
without docu buffer attribute
there has been a
cancellation, the step
number will be given the
number 0.
Step category List (expandable) – End tightening
mode
– Step type
End tightening
mode
Sets the step category for the
IPM data output
– End tightening mode
Possible output values are
either "unknown" or "end
tightening".
"Final tightening" is only
output if the step number is
identical with the buffered
final tightening step number
of an OK tightening of this
AFO completed in advance.
– Step type
The number of the step type
of the tightening step of the
tightening system is
accepted without changes.
Step filter List (expandable) – Docu steps +
result step
– Result step
Docu steps + result
step
Sets the tightening steps that
are transferred to the IPM
Step output order List (expandable) – sequential sequential Sets the order in which the
tightening steps are forwarded
to the IPM
1 If the table does not contain a combination of channel/program, the data is always forwarded to the IPM gateway
(with an automatically generated AFO) so that no data can get lost.
Table 6–144: Definition of the work sequences (AFO-lines) in the view configuration Rexroth IPM Protocol
Element Type Value range Standard value Comment
To Next Page
Loading...
