10
IFS 125M User Manual Bruker Optik GmbH
Introduction 1
1.2 Terms
This manual uses both the term spectrometer or IFS 125M when the spectrometer is
described.
1.3 Safety
Always observe the instructions described in this manual to ensure user safety and to
avoid property damage. Keep this manual for further reference available at any time.
Improper use or failure to follow the safety instructions can result in serious injuries and/
or property damage. Any non-observance infringes the intended use (i.e. spectroscopic
measurements) of the spectrometer. In this case Bruker Optik GmbH does not assume
any liability.
It is the operator's duty to plan and implement all necessary safety measures and to
supervise their observance. Moreover, the operator must ensure that the spectrometer is
in proper condition and fully functioning. A safe and faultless operation can only be guar
-
anteed if the spectrometer is transported, stored, installed, operated and maintained
properly according to the procedures and instructions described in this manual.
Never remove or deactivate any supporting safety systems during spectrometer opera-
tion. Objects and/or material not required for operation must not be kept near the spec-
trometer operating area.
The spectrometer has been developed according to the EN 61010-1:2010 (IEC 61010-
1:2010+Cor.:2011) safety regulations for electrical measuring, control and laboratory
devices.
1.3.1 Warning labels
When operating the spectrometer you have to observe a number of safety instructions
which are highlighted by the appropriate warning label. The warning labels and their
meaning are described in the following.
All warning labels on the spectrometer must always be kept legible. Immediately replace
worn or damaged labels.
Label Definition
General Hazard:
This warning symbol indicates general hazard. Observe the safety
instructions and follow the precautions described to avoid personal
injury and/or property damage.
Table 1.1: Warning labels