46
IFS 125M User Manual Bruker Optik GmbH
Operation 5
5.4 Starting spectroscopy software
If the PC has finished booting, start the OPUS spectroscopy software which has been
pre-installed on the PC. How to start OPUS is described in the OPUS Reference Man
-
ual.
5.4.1 Setting up the connection to the optics
1. On the OPUS Measure menu, select the Optic Setup and Service command.
2. Click the Optical Bench tab and select the IFS125 spectrometer type from the Con-
figuration drop-down list.
3. Enter correct IP address (see chapter 3.7.1.1).
4. Click the Save Settings button.
➣ OPUS status light at the lower right end of the OPUS interface has to change
from gray to red, yellow or green. If the status light remains gray, see
chapter 7.7.
i
The settings saved remain, unless the IP address of the optics has been changed, or a
different spectrometer type is to be accessed.
To Next Page
Loading...
Need help?
General
