28
Sync Camera Assembly
(3) Ball Detect - (J27,J32) Connections for the ball detector signals. When used in a system with
pin cameras, these connections provide power for the ball detectors and an input for the signal
that starts the scoring process and is used to determine ball speed. They are also used in GS
pinsetters to monitor the GS pinsetter’s ball detectors so that ball speed can be calculated. Also
refer to Ball Detect Jumper (JP17) and Ball Detect LEDs (D73,D102).
J27 - Odd (left) lane
J32 - Even (right) lane
(4) Sweep / Throw Switch - (J33,J34) Connections for the signal from the sweep/rake switch
installed on the pinsetter when pin cameras are used for scoring. These connections are not used
with GS pinsetter installations. Also refer to Sweep Switch / Throw LEDs (D61,D62, D75,D84).
J33 - Odd (left) lane
J34 - Even (right) lane
(5) Switch Cluster / New Pins Solenoid - (J22,J24) Connections for the signals from the 0 degree
and 44 degree switches and the New Pin Solenoids (NPS) that may be installed as an option for
A-2 pinsetters. Also refer to Switch Cluster LEDs (D46-D49) and NPS LEDs (D50,D58).
J22 - Odd (left) lane
J24 - Even (right) lane
(6) Foul - (J35) Input for the signals from the foul units for both the left and right lanes. Also refer to
Foul Jumper (JP18) and Foul LEDs (D69,D94).
(7) AMF Short Cycle - (J36,J37) Connection to the AMF 8270MP pinspotter to allow the
machines to perform a short cycle when needed. Also refer to AMF Short Cycle LEDs
(D59,D64).
J36 - Odd (left) lane
J37 - Even (right) lane
(8) Spare Input - (J28) Reserved for future use.
(9) Spare Output - (J29) Reserved for future use.
(10) AMF Bumper Control - (J26) Connection to AMF automated bumpers. Also refer to AMF
Bumper Control LEDs (D34,D41).
(11) Even Lane Control - (J25) Connection to the even (right) lane pinsetter. The distribution PCB
turns the even lane pinsetter on/off by energizing relay K3 and resets (cycle) the pinsetter by
energizing relay K4. LED D19 turns “on” when the pinsetter power relay (K1) energizes. LED
D23 turns “on” when the pinsetter reset relay (K2) energizes. This connector is not used for
installations with GS Series pinsetters.
(12) Odd Lane Control - (J23) Connection to the odd (left) lane pinsetter. The distribution PCB
turns the even lane pinsetter on/off by energizing relay K1 and resets (cycle) the pinsetter by
energizing relay K2. LED D27 turns “on” when the pinsetter power relay (K1) energizes. LED
D33 turns “on” when the pinsetter reset relay (K4) energizes. This connector is not used for
installations with GS Series pinsetters.
To Next Page
Loading...