Sync Camera Assembly
29
(13) ISP - (J20) In system programming connector for manufacturer’s use only.
(14) Spare Communication Connectors - (J18,J19) Normally theses connection are not used. For
centers equipped with an Intellishield ball lift safety device, J18 is used for communication to
the Intellishield Controller. Jumper JP20 is used to select RS-232 or RS-485 communication.
(15) Brunswick Bumper Communication - (J15,J16) Internal connection point for the cable that
attaches to the external “Bumper” connector located on the bottom of the Peripheral Controller.
This connector is used to communicate to optional Brunswick automated bumpers. The output
connection (J16) is not used.
(16) GS Pinsetter Communication - (J8,J9) Internal connection point for the cable that attaches
to the external “GS Pinsetter” connector located on the bottom of the Peripheral Controller.
Connection that provides RS-485 communication for GS series Pinsetters. The output
connection (J9) is not used.
(17) RS-485 Connections - (J8,J9,J15,J16,J18,J19) Connections that provides RS-485
communication for GS series Pinsetters (J8) and optional Brunswick automated bumpers (J15).
Connection J18 can be switched between RS-232 and RS-485 using jumper JP20. For centers
equipped with an Intellishield ball lift safety device, the connection is used to communicate
with the Intellishield Controller using RS-485. Output connections (J9,J16 and J19) are not used.
(18) Pin Camera RS-232 - (J7) Internal connection point for the cable that attaches to the external
“Camera” connector located on the bottom of the Peripheral Controller. This connection
provides +12VDC power for the pin camera.
(19) Keypads - (J6) Internal connection point for the cable that attaches to the external “Keypad”
connector located on the bottom of the Peripheral Controller. This connection provides +12VDC
power and RS-232 communication for the Sync Touchpad and Vector Keypads.
(20) USB Connectors - (J1,J5) Not Used. For manufacturer’s use only.
(21) Programming Ports - (J13,J14) For factory use only.
(22) Video Out - (LCD1) For factory use only.
(23) Pin Camera Video - (J3) Connection for the video originating at the pin camera.
(24) LCD Contrast Control - (PT1) For factory use only.
(25) LCD Display - (J21) For factory use only
To Next Page
Loading...
