Sync Camera Assembly
31
(4) Switch Cluster Switches - (D46 - D49) These LEDs light to indicate when the zero degree and
44 degree switches that are available as an option on A-2 pinsetters are “closed”.
D46 (red) - Right Lane 44 degree switch
D47 (red) - Right Lane 0 degree switch
D48 (green) - Left Lane 0 degree switch
D49 (green) - Left Lane 44 degree switch
(5) Ball Detect - (D73,D102) These LEDs turn “ON” when a ball detect signal occurs.
D73 (green) - Left lane ball detect
D102 (red) - Right lane ball detect
(6) Sweep Switch / Throw - (D61,D62,D75,D84) These LEDs turn “ON” when the sweep switch
on the pinsetter is actuated and when the pinsetter is on rst ball. These LEDs are only used for
installations equipped with pin cameras.
D61 (green) - Left lane sweep switch
D62 (green) - Left lane 1st ball
D75 (red) - Right lane sweep switch
D84 (red) - Left lane 1st ball
(7) Foul - (D69,D94) These LED turn “ON” when the board is receiving a foul signal. These LEDs
are not used for GS Series pinsetters installations.
D69 (green) - Left lane foul signal
D94 (red) - Right lane foul signal
(8) AMF Short Cycle - (D59,D64) These LED turn “ON” when the short cycle signal is sent to the
AMF pinspotter.
D59 (green) - Left lane short cycle
D64 (red) - Right lane short cycle
(9) Spare Input - (D53-D56) Not Used.
(10) Spare Output - (D95-D98) Not Used.
(11) AMF Bumper - (D34, D41) These LEDs turn “ON” when a signal (voltage) is sent to the AMF
automated bumpers.
D34 (green) - Left lane bumpers
D41 (red) - Right lane bumpers
(12) Lane Control - (D32,D33,D39,D40) These LEDs turn “ON” when the relays to turn on or reset
the pinsetters are energized. These LEDs are not used for GS Series pinsetters installations.
D32 (green) - Left lane power (K1 energized)
D33 (green) - Left lane reset (K2 energized)
D39 (red) - Right lane power (K3 energized)
D40 (red) - Right lane reset (K4 energized)
To Next Page
Loading...
