Setting Up the Machine to Receive Faxes
Press .
Use / to select <RX Mode>, and press .
Select the receiving method, and press .
When selecting <Fax/Tel Auto Switch>
TIPS
If you want to print received documents on both sides of paper: Print on Both Sides
If you want to print information, such as reception date and time, at the bottom of received documents:
RX Page Footer
If you want to continue printing even when the toner is low:
Continue Printing When Toner Is Low
Using a Telephone to Receive Faxes (Remote Reception)
When you pick up the telephone and get a fax signal, you do not need to go to the machine to receive the fax. Just enter a specific ID
number (default setting: 25) with the telephone, and you can start receiving the fax.
When an incoming call rings, pick up the telephone handset.
If you hear a beep, enter the ID number for Remote Reception with the telephone.
Specify
the
following
three
settings
as
necessary. When
the
setting
is
complete,
press <Apply>.
<Ring Start Time>
Enables you to specify the duration during which the machine determines whether an incoming call is a fax or a
telephone call. (Setting values: 5 to 30 seconds; default setting: 8 seconds)
<Incoming Ring Time>
Enables you to specify the duration during which an incoming call rings for a telephone call. (Setting values: 15 to 300
seconds; default setting: 22 seconds)
<After Ring>
Enables you to specify how the machine operates if you do not pick up the handset while an incoming call is ringing.
Select <End> to disconnect the call or <Receive> to receive an incoming fax. (Default setting: <Receive>)
1
2
3
1
2
㻝㻡㻡㻌㻛㻌㻢㻣㻢
To Next Page
Loading...
