Ceia THS/MS21 - Page 11

FI002K0018v1100UK – THS/21 Instruction manual for installation, use and maintenance
1
SAFETY INSTRUCTIONS -
W
ARNINGS
ORIGINAL INSTRUCTIONS 11
- Only connect up the compressed air supply after you have completed installation of the device
and made all the other connections.
- Before connecting the device to the power supply, ensure that the power supply voltage
corresponds to that indicated on the rating plate attached to the device. Checking that the
power supply conforms to the values specified on the rating plate and to the regulations in force
is the responsibility of the customer.
- The power supply must be fitted with an earth/ground connection. Any break in the safety
conductor, either inside or outside the device, or disconnection of the earth/ground safety
terminal, will render the device dangerous. Intentional cutting or disconnection is strictly
forbidden.
- The device should be connected to the mains power supply only after all connections required
for full installation have been completed.
- To avoid damage due to lightning, fit the power supply line with appropriate surge suppressors.
- The installation and handling of systems with wheels is allowed only on level floors.
- After installation the device should be stable and not subject to vibration or accidental
movement. On systems with castors, the castors should be locked. On systems with feet, these
must be anchored to the floor.
All connecting cables should be properly fastened down, in order to avoid knocks and
accidental damage and to ensure optimum performance.
- Once the electrical connections have been completed, seal the unused cable glands to stop
water or other foreign bodies entering the power supply unit.
- There are dangerous voltages inside the power supply unit. Close the cover and keep the key
safe so that it is only available for use by authorized, trained personnel (EN 60204 standard).
- During installation take precautions to protect the detector opening or inside surface from
damage. Do not use the opening for lifting.
- When you have completed installation, check the area around the machine for safety hazards.
Check that there is sufficient space for the operator to work with the equipment.
- Installation and additional final testing is the responsibility of the final user.